Orca LAB Phospha-Guard GFH RE-CYCLE 1.2 kg

The 1.2kg Phospha-Guard RE-CYCLE can regenerate up to 1.5kg of absorbents.

How to use 
Mix 200g of Phospha-Guard Re-cycle in 1.5 liters of warm tap water (not hot or boiling). This amount will allow the regeneration of approximately 250ml of phosphate absorbing media. Soak Phospha-Guard in this solution for 24 hours. This will regenerate Phospha-Guard. For better regeneration, an additional procedure is required. You will need a 2-liter plastic bottle with the bottom cut off and a hole in the cap. Turn the bottle upside down and fill it with the media. The bottle should stand in another half-cut bottle or any vertical container upside down. Then, pour the prepared solution in which the absorbent was soaked over the inverted bottle, allowing it to slowly pass through the media. Adjust the size of the hole in the cap of this bottle so that the flow lasts at least 25 minutes. It is best if this process proceeds slowly and is done twice. After this treatment, the media will be best regenerated. In the same way, after regeneration, pass about 4 liters of RO water through the media before placing it in the aquarium.